To the page content

Signal Generator

  • With the built-in 1 Watt amplifier this device is ideal for (8 Ohm) speaker tests
  • Line output for active speaker or mixer tests
  • Tunable frequency between 20 Hz and 20 kHz
  • Power supply with 9V block battery
  • Output switchable between XLR line or speaker twist for the speaker test
  • Dimensions: 110 x 72 x 40 mm
  • Available since February 2014
  • Item number 326025
  • Sales Unit 1 piece(s)
  • Cable Tester No
  • Level Meter No
  • Speaker Tester No
  • Software No
£33
All prices incl. VAT
In stock
1

84 Customer ratings

4.4 / 5

features

quality

48 Reviews

PR
Great little gadget.
Peter R. 438 27.07.2015
Test all your speakers/ horns "full range" and even amps/desks/cables/etc, this little thing even helps setting up sound at gigs.

Mine had problems when it arrived, didn't work at all, the screws holding the belt clip were too long, pushing against the circuit board inside, earthing the signal, I just guessed this and removed the screws, hey presto!

I found a faulty horn in one of my PA speakers simply by plugging in and listening, BUT DO BE CAREFUL WITH YOUR EARS, one watt is enough to blow your ears as you listen closely or even not so closely, please be careful.

There's far more expensive ones but why pay more.
quality
features
0
0
Report

Report

SE
Naja, da ist noch Luft nach oben
Sheik Eggshake 05.10.2024
Zwar stabil, aber billig gebaut. scharfkantige Gürtelklemme und die Batterieklappe ist ein schlechter Witz: sie wird an der einen Seite nur von der kleinen Schraube gehalten und an der anderen Seite von gar nix. Batteriefächer aus Pappe habe ich das letzte mal in den 1970ern gesehen.
Der Signalgenerator ist auch nicht so doll, da er auch an 8 Ohm ganz schnell verzerrt. Damit möchte ich keine Qualitativen Aussagen über den Zusatend von Lautsprechern ermitteln müssen. Und de Hinweis, dass die beiligenden Gummifüße eventuell färben?? Ausserhalb Chinas sollen inzwischen auch schon nicht färbende Exemplare gesichtet worden sein.
Trotzdem nützlich, könnte aber mal modernisiert werden. Und bitte: den On/Off Schalter so platzieren, das man ihn NICHT versehentlich einschalten kann.
quality
features
0
0
Report

Report

KA
Not as advertised.
Kjetil A.S Pettersen 04.08.2026
I purchased my unit to test speakers and to ring out rooms with adjustable sinesweeps. When I got my unit, it did not generate sine sweeps from 20hz to 20khz. it went from 400hz down to 200hz and up to 20khz according to my spectrum analyzer. Inside the unit, there is a blue trimpot to adjust the oscillator range. This was off kilter. And after adjusting with my spectrum analyzer, the unit works better, but is only accurate between 32hz and 500hz. The unit does not produce a clean sine wave, since there are always 4-6 harmonic overtones 1 octave apart each other above the fundamental frequency. The sinewave looks sine-ish on a oscilloscope, but contains alot of harmonics. The amplifier on the speakon output puts out about 2,6vAC (0,4w@16ohms, 0,8w@8ohms, 1,7w@4ohms and 3,4w@2ohms), a bit under the 2,83vAC or 1 watt @ 8 ohms as advertised.

If you need accuracy, buy something else.
But for discovering room modes and low frequency resonances in a venue, and once calibrated, it's an affordable and somewhat useful tool.

If you only need something to make noise, it will make noise. Useful for troubleshooting bad speakerdrivers.
quality
features
0
0
Report

Report

K
Great tool!
Kikass 20.10.2025
If you want a Soundbullet but can't afford the price, this is your option. Even better because you have Speakon out. Very good for instalations you can test the speakers, active or passive, so no need for a amp when labeling cables!
quality
features
0
0
Report

Report